VMC Electronic Ignition Cone 19 In CNC For Vespa Small Frame
VMC ignition cone 19 In CNC for vespa 50/50 special / et3 / primavera / pk50-125
Suitable for high performance engines
Flywheel made from solid weight of approximately 1200g with the fan the total weight is 1500g
On the CNC flywheel it is possible to screw an additional weight of your choice between 210gr, 410gr, 610gr, 820gr.
The VMC ignition has a variable advance of 8° complete with stabilizer and IDM coil
Aluminum cooling fan with increased fin profile to increase air flow and better cool the thermal unit even in the most demanding conditions
Fans available in different finishes and materials with more or less fins depending on the type of engine
The ignition delivers approximately 90 watts of power and uses 12-volt bulbs (this modification requires replacing the bulbs in models that use 6-volt bulbs).
Ensures greater recovery, extension and acceleration thanks to the ignition advance that varies by 8° degrees leaving a cooler cylinder at high revs
The ideal ignition for most engines both tuned and original
The stator has an auxiliary cable for the possible charging of a battery that can be managed through the voltage regulator supplied
The instructions are also available in digital format in the attachments section.
Specific References
In Italy and Europe Via GLS / DHL / Fercam
24h from order confirmation
Secure via Paypal, Credit Card, Bank Transfer, Installment Payment
Related products
Questions
Be the first to ask a question about this product!