VMC CNC Electronic Ignition For Vespa Large Frame PX
for Vespa 125 GTR 2nd/TS 2nd/150 Sprint V 2nd/Super 2nd/200 Rally 2nd/PX80-200/PE/Lusso/Cosa
flywheel: 1800g
cone 20 , M12
VMC PX Ignition with CNC Flywheel and CNC Fan for Vespa px125-150, p200e, Cosa, LmL 2t, Vespa big frame in general
The weight of the CNC Flywheel + CNC Fan is approximately 1500gr
For use on tuned engines it is recommended to combine an additional weight of 410g or 610g.
The ignition delivers approximately 90 watts of power and uses 12-volt bulbs (this modification requires replacing the bulbs in models that use 6-volt bulbs).
Ensures greater recovery, extension and acceleration thanks to the ignition advance that varies by 8° degrees leaving a cooler cylinder at high revs
The ideal ignition for most engines both tuned and original
The stator has an auxiliary cable for the possible charging of a battery that can be managed through the voltage regulator supplied
The instructions are also available in digital format in the attachments section.
Specific References
In Italy and Europe Via GLS / DHL / Fercam
24h from order confirmation
Secure via Paypal, Credit Card, Bank Transfer, Installment Payment
Related products
Questions
| Sabatino on 06/04/2023 |
Question: Buona sera, posso montarla su p125x prima serie senza frecce con impianto a 6v. Inoltre quali altre modifiche dovrei apportare 06/04/2023 |
Answer: Probabilmente dovrà o mettere un raddrizzatore da 12 a 6 v o cambiare impianto elettrico essendo 12 V questa 11/04/2023 |
|