VMC CNC Electronic Ignition For Vespa Large Frame PX + Additional Weight
VMC CNC Electronic Ignition For Vespa Large Frame PX
- This product is out of stock.
- 10 Fin Fusion Fan
Mass For Flywheel Ignition vmc in cnc
- 210 g
- 410 g
- 610 g
- 820 g
One of product is no longer available. This pack cant be purchased
In Italy and Europe Via GLS / DHL / Fercam
24h from order confirmation
Secure via Paypal, Credit Card, Bank Transfer, Installment Payment
Pack description
VMC ignition with CNC flywheel complete with screw-on ADDITIONAL WEIGHT.
You can choose between 4 different weights:
210gr + Flywheel 1200gr + Fan 300gr = approximately 1710gr
410gr + Flywheel 1200gr + Fan 300gr = approximately 1910gr
610gr + Flywheel 1200gr + Fan 300gr = approximately 2110gr
820gr + Flywheel 1200gr + Fan 300gr = approximately 2320gr
Only available with 14-blade die-cast fan
The instructions are also available in digital format in the attachments section.
The ignition connections on Vespa Px/Pe are as follows
black cable to ground on the small pin of the Idm control unit/coil
and in bridge with the black cable that comes from the electrical system of the Vespa
blue wire on the big pin of the Idm control unit/coil
and in bridge with the green cable for the shutdown that comes from the electrical system of the Vespa
white cable AC output to be connected to the blue cable of the electrical system
you can use the original voltage regulator
The instructions are also available in digital format in the attachments section.
Pack content
for Vespa 125 GTR 2nd/TS 2nd/150 Sprint V 2nd/Super 2nd/200 Rally 2nd/PX80-200/PE/Lusso/Cosa
flywheel: 1800g
cone 20 , M12
VMC PX Ignition with CNC Flywheel and CNC Fan for Vespa px125-150, p200e, Cosa, LmL 2t, Vespa big frame in general
The weight of the CNC Flywheel + CNC Fan is approximately 1500gr
For use on tuned engines it is recommended to combine an additional weight of 410g or 610g.
The ignition delivers approximately 90 watts of power and uses 12-volt bulbs (this modification requires replacing the bulbs in models that use 6-volt bulbs).
Ensures greater recovery, extension and acceleration thanks to the ignition advance that varies by 8° degrees leaving a cooler cylinder at high revs
The ideal ignition for most engines both tuned and original
The stator has an auxiliary cable for the possible charging of a battery that can be managed through the voltage regulator supplied
The instructions are also available in digital format in the attachments section.
Mass For Flywheel Ignition vmc in cnc
The 820gr weight does not fit on original Piaggio or aftermarket standard smallframe crankcases that have a dust lip.
Questions
Be the first to ask a question about this product!